Antilock Brake Sensors

Part Number	From	To	Comments	Suggested Retail
F0VY-2C204-AA BRAB-98	1992	1994	Antilock Brake Sensor	$61.57
F5AZ-2C204-AA BRAB-44	1995	1997	Antilock Brake Sensor	$37.02
F8AZ-2C204-AB BRAB-75	1998	2002	Antilock Brake Sensor	$27.70
N605518-S436	1995	2002	Sensor -> Knuckle Bolt M6 x 1.0 x 20 Hex Head Supercedes: N605518-S428 and N605518-S428A	$4.48

Notes:

• ABS sensors are interchangeable from the passenger side to the drivers side
  
• Due to corrosion, antilock brake sensors are often very difficult to remove from the knuckle without damage to the sensor. An alternative to removing the sensor from the knuckle in some instances is to unplug it's electrical harness in the engine bay, pull the cable into the wheel well area and secure it out of the way
• The front passenger fender apron has a tendency to wear through the antilock brake cable around where it passes in between the frame and the apron.
• The stamped steel abs tone ring on 1992-1997 vehicles can corrode severly on "rust belt" vehicles resulting in missing teeth and debris magnetically sticking to the sensor. This may cause various difficult to pinpoint antilock brake related problems. 1998+ vehicles use a redesigned tone ring constructed of high grade stainless steel that is not subject to this problem.
  

Brake Dustshields

F2AZ-2K005-A	1992	1994	Except Police Left	Obsolete
F2AZ-2K005-B	1992	1994	Police Left	Obsolete
F5AZ-2K005-A	1995	2002	Civilian and Police Left	$21.55
F2AZ-2K004-A	1992	1994	Except Police Right	Obsolete
F2AZ-2K004-B	1992	1994	Police Right	Obsolete
F5AZ-2K004-A	1995	2002	Civilian and Police Right	$20.13

Notes

• The procedure listed in the factory service manual for replacing the lower balljoints states that the brake dust shield rivets should be drilled out and the shield removed from the knuckle prior to lower balljoint replacement. To reinforce this point, the F8AZ-3050-AA lower balljoint kit from ford includes six new rivets. But most mechanics just bend the dust shield out of the way when they seperate the lower ball joint from the steering knuckle. And then bend the shield back relatively straight after the new joint is installed.
  
• If you purchase a salvage yard steering knuckle be warned that the lower portion of the dust shield may be bent or torn beyond repair.
• The brake dust shield also retains the antilock brake sensor wiring
  

Caliper Bracket -> Steering Knuckle Bolts

Part Number	From	To	Comments	Suggested Retail
N808237-S101A	1995	2002	Bolt M14x2.0x31 Hex Flg HD Supercedes N808237-S100 and N808237-S101	$5.98

Notes:

• The bolts which retain the caliper bracket to the knuckle have factory installed thread locker. A 24 inch breaker bar with a strong impact socket should be able to loosen these bolts without too much trouble. Attempting to use a 3/8" drive socket set from walmart on these bolts would not be productive though.